 |  |
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors |
| ||||
|
#1
04-07-2007, 04:03 PM
| |||
| |||
| Require Assistance for fibreglass boat design I have the prelimnary design as follows: LOA 6meters Beam 2Meters LWL 3.5Meters Six seater Runabout (Semi displacement hull) Deadrise 20degrees Speed 20Knots Engine Evinrude 40Hp ETEC. Hull thickness 8mm Transverse stringers 8mm thk @ 500mm intervals Longitudinal stringers 4Numbers 8mm thk. Transom: 50mm thk. Open mould vacuum bagging operation. Can anyone check to see if the above calculated specs are OK. Thanks.  Amateur Student.  |
 |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fibreglass repair on a speed boat hull. | bigsk74 | Powerboats | 2 | 08-30-2006 10:48 AM |
| Rc Boat Fibreglass mould | AleX`G | Fiberglass and Composite Boat Building | 4 | 07-18-2006 03:31 PM |
| Fibreglass Boat Plans Please, Or help of buying a hull | Fingers_21 | Powerboats | 0 | 01-10-2006 07:02 AM |
| Require Information over Yacht Design | Jannner | Education | 1 | 07-14-2005 05:23 AM |
| Do diesel engines require bilge blowers? | Powerboats | 4 | 11-05-2002 06:48 AM | |
Linear Mode
