 |  |
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors |
| ||||
|
#1
11-11-2004, 09:02 PM
| |||
| |||
| flat table3 panels Looking to do large flat table glass panels for plug building. Naive question perhaps, if I use mica or melamine,\to surface the table.how should I deal with th butt joints on the mica. leave them negative and fair the plug or attempt to fill/clay them before laying up panel?  |
 |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to Create 3D Hull from Flat Panels? | DougChapman | Software | 4 | 09-20-2005 01:03 PM |
| Longitudinal stringers or Transverse ribs for flat bottom | dick stave | Boat Design | 1 | 02-13-2005 07:03 AM |
| Fiberglass Flat Panels: Sources needed | BillB | Fiberglass and Composite Boat Building | 6 | 08-05-2004 10:57 PM |
| Stepped Hulls | Ryon Macey | Powerboats | 53 | 08-01-2004 10:44 AM |
| Unfolding formed boat panels to flat sheet | Rohan_Tink | Metal Boat Building | 3 | 02-23-2004 10:02 PM |
Linear Mode
