 |  |
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Wiki (beta) | Boat Design Book Store | Thanks to Our Site Sponsors | Sitemap |
| ||||
| |||||||
 |
| | Thread Tools | Search this Thread | Display Modes |
|
#1
03-29-2004, 08:52 PM
| |||
| |||
| Decision of the Shaft Center Line position in Twin Screwed Boats The Shaft Center line position on the plan view of the ship should be the breadth of full load water plane divided by 4. Is it true ? I belived that this may be varied according to the type of the hull forms. Any rule of thumb or specific formulas ? Thanks Donald  |
|
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| the egotistical quest for an expensive thrill | deepkeeler | Boat Design | 179 | 08-31-2006 10:32 PM |
| Self Righting Rig | Wardi | Sailboats | 14 | 06-29-2005 02:03 PM |
| Heavy sailboats : Can they point ? | xarax | Sailboats | 100 | 06-24-2005 10:36 PM |
Linear Mode
