 |  |
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors |
| ||||
|
#1
03-10-2008, 09:28 PM
| ||||
| ||||
| Anyone who is using Solidworks Macro? I have a problem on writing codes for a macro that would automate a molding block to have a cut for cooling channels inside. Note:Automation of creating the channel on any given block is the requirement. Thanks  |
 |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| For SolidWorks users: an interview with Matt Lombard (SolidWorks 2007 Bible author) | folini | Software | 0 | 05-11-2007 02:50 PM |
| GHS Macro Commands? | GhrarhG | Software | 8 | 02-13-2006 04:41 PM |
| Solidworks | asathor | Software | 1 | 11-11-2004 09:34 PM |
| SolidWorks | SAQuestor | Software | 0 | 09-22-2004 12:28 PM |
| SolidWorks | Nomad | Software | 14 | 08-05-2004 09:14 AM |
Linear Mode
