My little piece of peace

Mas should stay, though I don't always(only maybe 40%) agree with him, because even though the endless postings become tedious, he is at heart a decent fellow with a common interest in all things boat, which may save him from obsession with all things gold.

 

Nothing wrong with Mas - he's ok
we all go al little overboard from time to tiime
if you dont like it dont read it
if you dont like it why reply?
like most things - if you look for a scrap you will probably get it

anyway back to boats birds and beer

 

Boats, beer, birds, ******** and bugger all else - - - the 5 important B's of life :B :B :B :B :B - -

Here is another 5 on boats:

 

You´ve cut those campionways too small Mas, are you vertically challenged?

 

Haven't you seen this earlier picture of Mas....... and he's a lot younger than you'd think too.

 

Why does it say on the yellow sticker 'Please remove sticker from panel before use?' !!

 

RHP,
Correct it is the peelply marker - I believe some fool left the peelply in place and just painted... so with the amine blush (wax) and dirt of the build, the paint would not stick and the seal was not waterproof
Judy,
I am a 'timelord' (not "Doctor Who" - a character based on me, but 'a masalai' or spirit being), and regularly regenerate, 20 seconds later I was "fullgrown mature" amazing isn't it - - - Little grandson then three-and-a-half - - -

 

Standing on the stbd bow

 

That is probably it, as for photographs, until after the Xmas break when work will commence on the bridgedeck-coachhouse.... The team are busy sanding, bogging, sanding, bogging, sanding, undercoating etc etc...

With the work on the coach-house and weight estimates, final positioning for heavy items will be considered, placement of winches, some smaller hatches and safety rails and.... and.... and.... the list is listed...

Have a peaceful and pleasant time with your families and friends, all the best - - masalai...

 

Happy Christmas (Celebrate the birth of Christ) and a Prosperous New Year - go gold

On change of resin drums an Oops (possibly cross contamination of batches is not good as first mix refused to harden so everything had to be ripped and cut out - What a "painful task"... Other shots are just what has been done - in part....

 

Drilling holes to test the batch before and after - both OK

 

Finishing the trim and strengthening of the "duckboard" and stern sections...

 

Your making it look easy Mas, Im sure it is'nt.

Im off to Malaysia where Christmas is less----- humbug.

Christmas does not start till 25th we are now in 'lent'

I hate it, and yes I am a grumpy ole fart, which is one of the more endearing sides to my personality,--apparently.

 

Depends on what you call "easy"? - opening my wallet and forever pulling out big wads of money to pay for things....

 

That bit may be easy but how did the big wads of money get in your wallet in the first place. Ille bet that was'nt easy as many people go into Christmas with little to eat.

You mean your workers are on Christmas break already?

How many days after?

Refer to my opinion of Australia taxes thread.