help me ID this motor

don954 · #1 02-24-2005, 12:34 AM

The boat i was given recently has a motor that seems to work despite its rust. I only ran it for about 10 sec. I wish to go ahead and pull it and rebuild it due to its immersion in fresh water. a photo is attached, and a link to a high res photo is below. This is a GAS motor with 2 cyl, carbed not injected, simple non-computerized spark too. This is prob a stock motor on this boat, an Ericson 27
http://www.helpmenetwork.com/images/P2222953.JPG

don954 · #2 02-24-2005, 10:39 PM

FYI, i have IDed it as a Volvo Penta MB 10A

Alexph · #3 02-25-2005, 05:13 PM

Yeah it is a Volvo Penta MB 10 a i remember as i did a couple of college tests on the things!!

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
anchor winch motor	Peter Baker	Electrical Systems	2	07-13-2005 10:32 AM
pontoon motor mount	kcard2112	Boat Design	1	05-11-2005 10:43 PM
short shaft motor on long shaft boat	ohenry	Boat Design	0	03-21-2005 09:02 PM
Cavitation and Mounting Motor	Colin Hartley	Open Discussion: All Things Boats & Boating	2	12-15-2004 01:12 AM
Combination CB trunk / Motor well	wwheeler	Wooden Boat Building and Restoration	14	04-05-2004 10:05 PM