cmcguinness
12-01-2004, 02:52 PM
Dear All & Andrew,
Aint having any luck in trying to convert my lines-plan of a fishing vessel into Maxsurf etc. Previously got advice (See below, & Andrew if your out there, cheers) before but I cant seen to achieve it. Basically I keep getting the following error, " the file does not appear to be in valid DXF format". My Plan-lines are in AutoCAD2002, and Maxsurf file , just dont see it? I know i'm missing out a very simple step here, but I cant see it . Any advice, or Maxsurf for Dummy's guide?
Regards
cmcguinness
"Go to Fule->Import and choose either DXF background (in which case the 3D polylines will show as a 3D wireframe), or DXF Markers, in which case they will display as 3D marker (i.e. offset) points.
Marker points can be used for automated fitting using the Fit Surface to Markers command, however this option is enabled only if you have purchased the Prefit module."
Aint having any luck in trying to convert my lines-plan of a fishing vessel into Maxsurf etc. Previously got advice (See below, & Andrew if your out there, cheers) before but I cant seen to achieve it. Basically I keep getting the following error, " the file does not appear to be in valid DXF format". My Plan-lines are in AutoCAD2002, and Maxsurf file , just dont see it? I know i'm missing out a very simple step here, but I cant see it . Any advice, or Maxsurf for Dummy's guide?
Regards
cmcguinness
"Go to Fule->Import and choose either DXF background (in which case the 3D polylines will show as a 3D wireframe), or DXF Markers, in which case they will display as 3D marker (i.e. offset) points.
Marker points can be used for automated fitting using the Fit Surface to Markers command, however this option is enabled only if you have purchased the Prefit module."