flow net/mesh for infusing

[Vanbokklen]

Anyone like to give any tips on the best place to buy surface flow netting for resin infusing?

Airtech is $100 for their 60" x 88' roll of red LPDE netting:
https://www.airtechonline.com/Airtechstore/datasheets/data023.htm

Is there anyplace to get it cheaper and possibly even softer more flexable material? Maybe even something different than a netting like that which Airflow sells? Less expensive is important.

[SailDesign]

Is there anyplace to get it cheaper and possibly even softer more flexable material?

http://www.verdantresins.com/PB_Frontx.html

:)

[Vanbokklen]

http://www.verdantresins.com/PB_Frontx.html
:)
Thanks. I will defintely look into this flow meduim. What you recommended here is an innerlaminate flow medium. It could possibly work good for some of my projects. But this medium you mention is Very Very expensive!!! It is quite a bit more cost than the Airflow stuff and a couple of other brands that I know about. But thanks again for pointing it out, I did not know of it.

Anyone else have a lead on "surface medium" netting/mesh with 1/8" strand spacing like the Airflow stuff, but just a whole lot cheaper. The Airflow stuff is only low denisity polyethelene mesh/netting and should not be near the price that Airflow wants for it. It has to be had much cheaper elsewhere. Anyone!?!

Or if there is another surface medium I can put above the peelply, maybe not a mesh even, that would work and be cheaper.

Send me a private message if you must. Thanks!