1998 johnson 150 lifting tool threads?

[pabble]

Hi...I'd like to make a lifting tool for a 1998 Johnson 150 outboard - can anyone tell me what thread size and bolt diameter will be needed? any related suggestions would also be appreciated. thanks.

[kenJ]

I've read this post several times. I still can't figure out what you are asking. Can you be more specific?

[pabble]

I've solved the problem but the question relates to the lifting tool referred to in the service manual in the section on "Lifting Information", where it states, "Install OMC Lifting Tool, P/N 342672, on crankshaft. Tighten mounting screw securely using......" etc. The picture showed a threaded pin that screws into place with a swivel lift point on the exposed end. Online they are priced high for one time use I thought, so wanted to make my own. However, when I took a second look at my outboards they had suitable lifting eyes already in place and I was able to lift them without problems. But thanks very much for your reply.
bryan