lazeyjack
07-24-2008, 08:55 PM
Anyone used hoop pine ply, it is very stiff, like very!
i have drawn a jig for our cab front, the tightest R is 500, (25in) 3 laminations,of 6mm
So i dunno if will clamp around, my exp with ply structure is kinda not too much the two outside lines are the ply the two inside represent steel tube which will be made up as a bow the ply is only about 17 inches deep
this is what i found, comments?
Bending guide - all measurements in inches.
plywood min across min with
thickness grain radius grain radius
1/4 24 60
5/16 24 72
3/8 36 96
1/2 72 144
5/8 96 192
3/4 144 240
The table tells us 1/4 inch plywood sould bend into a 4 ft circle
across the face grain and a 10 ft circle with the face grain.
i have drawn a jig for our cab front, the tightest R is 500, (25in) 3 laminations,of 6mm
So i dunno if will clamp around, my exp with ply structure is kinda not too much the two outside lines are the ply the two inside represent steel tube which will be made up as a bow the ply is only about 17 inches deep
this is what i found, comments?
Bending guide - all measurements in inches.
plywood min across min with
thickness grain radius grain radius
1/4 24 60
5/16 24 72
3/8 36 96
1/2 72 144
5/8 96 192
3/4 144 240
The table tells us 1/4 inch plywood sould bend into a 4 ft circle
across the face grain and a 10 ft circle with the face grain.