Voyager 57
01-13-2007, 10:14 AM
Hi gang,
I am new here so please don't shoot me down too soon, I'll try to get to the point quickly :) Ihave a 5.7 meter/ 19ft Whittley Voyager that has a volvo penta petrol engine "B20a" and a 270 leg. The B20a has a cracked head and has had salt water sitting in it for about six months before I got it, engine is a throw away!
The boat was very under powered with the 4cyl b20a, I had been trying to track down something else to replace it. I was offered marinised V6 pertol ford engine very very cheap:) :) and I am trying fit it to the volvo 270 stern drive in the boat using 4 engine mounts to the floor of the boat "the b20a's only mounting was to the stern drive nothing connecting it to the boat itself"
Then having it connect to the stern drive by the drive plate that was on the b20a fly wheel "it bolts straight on!"
But obvioulsy the bell housing and engine won't bolt up, the starters are in the same place, I can slide the engine into place and it almost fits!!! Only half an inch distance between the bell housing and the block!!! So so very close!
So here is my question can I just leave a gap ?? Can I not bolt the engine to the stern drive? The engine mounts hold it in place, I have weilded up a square frame connecting all the mounts so it's very stable.
Also the old b20a engine I think put out about 100hp, and would only just get up on the plane at 4000 RPM with 3 people in the boat. The new engine should put out about 130hp, can I put on a greater pitch prop and get on the plane with less revs??? and greater top end speed???
Any advise would be great thank you in advance.... :) :)
I am new here so please don't shoot me down too soon, I'll try to get to the point quickly :) Ihave a 5.7 meter/ 19ft Whittley Voyager that has a volvo penta petrol engine "B20a" and a 270 leg. The B20a has a cracked head and has had salt water sitting in it for about six months before I got it, engine is a throw away!
The boat was very under powered with the 4cyl b20a, I had been trying to track down something else to replace it. I was offered marinised V6 pertol ford engine very very cheap:) :) and I am trying fit it to the volvo 270 stern drive in the boat using 4 engine mounts to the floor of the boat "the b20a's only mounting was to the stern drive nothing connecting it to the boat itself"
Then having it connect to the stern drive by the drive plate that was on the b20a fly wheel "it bolts straight on!"
But obvioulsy the bell housing and engine won't bolt up, the starters are in the same place, I can slide the engine into place and it almost fits!!! Only half an inch distance between the bell housing and the block!!! So so very close!
So here is my question can I just leave a gap ?? Can I not bolt the engine to the stern drive? The engine mounts hold it in place, I have weilded up a square frame connecting all the mounts so it's very stable.
Also the old b20a engine I think put out about 100hp, and would only just get up on the plane at 4000 RPM with 3 people in the boat. The new engine should put out about 130hp, can I put on a greater pitch prop and get on the plane with less revs??? and greater top end speed???
Any advise would be great thank you in advance.... :) :)