Good aluminum fab shop in Seattle area?

[Bob S.]

I would like to find someone to perform some modifications on a 25' plate aluminum workboat that I own and was wondering if any of the NW folks on this board could recommend anyone? Or perhaps a mobile operator that would do the work at my shop? Thanks!

[CDBarry]

Throw a rock in the air with your eyes closed and it will land in a good aluminum boatbuilder's shop.

Seriously though, go by Kwichak, near the Fremont bridge and ask them, or ask at Elliott Bay Design Group on Shilshole nearthe Salmon Bay Cafe (www.ebdg.com).

[SolomonGrundy]

Damn, I went down into the shop today and had to get a snow shovel for all the rocks on the floor...now I know why.
I used to work at Kvichak, SafeBoats, Lee Shore and Townsend Bay. Now I have a fab shop here in P.T.
I'm an economical choice for boats under 50'.
jay_the_boatmaker@hotmail.com
360.379.4887

[Bob S.]

Thanks for the responses! Jay, I will send you an email with some info on what I would like done.