- breaking Alternator belts
- Engine Wont Turn.
- Blown: Need to Rebuild
- Thoughts on water in 350
- Wrong Prop?
- brand new to boating
- Prop size
- how to pull 305
- Prop sizing
- Mercruiser 3.0 Alpha
- Help!!! parts fell out
- Mercruiser shifter problem - shifter box
- My new boat has water in the 3.0 cylinders
- Help! riser & manifold?
- Alpha One No Go!
- Need some help/advice
- The Right prop....
- repower
- help help.....newbie
- Adding Hydrofoil Stabilizers to 28" Bayliner Contessa
- volvo steering helmut shaft
- resealing drive
- Boat is a NO-GO (stalls)
- Penta 5.0 sx only revs to 4000 rpm
- Excessive steam
- Loss of power
- steam thru prop hub merc 260?
- Merc Cruiser v-8 350 Thunderbolt Ignition
- Which oil for Volvo/ Penta 5.0L?
- Lower Unit HELP
- 6Cyl Ford Falcon to 280T Leg (adaptor plate)
- mercruiser 260 emitting steam
- Differences between Mercruiser 160 / 165
- 2bbl to 4bbl carb conversion
- Outdrive ratio??
- Oil leak from alpha 1 driveshaft
- Engine stalling in Four Winns Horizon RX 4.3L
- Sounds like BB's bouncing around in rocker compartment over 3500 rpm
- omc 140 leaking head?
- Upper outdrive problem
- carby or fuel injection
- carby or fuel injection
- Want to squeeze more power outta my 454
- Volvo Outdrive lube?
- Waster seepage Help
- Mercruiser 3.0 water inlet hose connector help
- VolvoPenta Water Pump??
- MisFire above 4000RPM after 20 min
- Volvo tilt
- 1970 OMC Drive
- Volvo 290 4cyl. To V8
- Need VP Jackshaft Info
- OMC Cobra to Volvo Duoprop
- Volvo-Penta Drive
- Electronic ignition install question
- black smoke on startup..Help
- volvo 270 steering helmet/fork
- Volvo Penta drive help!
- Stuck in Neutral
- help.alpha 1
- Small block camshaft
- Prop choice confusion
- Mercruiser 350 Leaking Manifolds and Milky Oil
- 1976 Imp
- Corsa captions choice noise
- 280 short and long shaft units
- merc 4.3 rebuild - cracked block
- volvo 280/270 gear ratio
- Volvo 270 to 280 conversion
- Expected fuel consumption?
- 4cyl. to v6 conversion
- Choosing between Volvo & Merc
- Carter/Weber AFB for marine
- Another SBC OMC Question (Circa 1980)
- New Guy Here with some questions Re: Chev 350 and Exhaust
- Exhausts comparison info wanted
- Morse Shifter
- mercruiser 170 224 ignition help
- OMC Transom shield Removal
- Convert Twins To Single Engine?
- mercruiser 170 224 slow cranking
- mercruiser 170 224 no spark help
- Vintage OMC- User Manual needed
- Auto vs. Marine - SBC Vortec
- How does volvo with cone drive compare with mercruiser
- Hyd Engine Tilt
- Wellcraft 23 Nova XL - I-6 for a v-8?
- Source for 1977 OMC 175 (302 Ford) exhaust manifolds
- Re-power - Long blocks from RapidO Marine in Miami
- Adding RamJet to 350 MAG
- torque Formula needed?
- Connecting a V6 ford engine to a Volvo Stern Drive Help...
- volvo penta stern drive
- ZEUS drive feedback?
- volvo stern drive puzzle
- marine vs. automotive - Vortec
- Volvo Penta 280B Rubber Hooks
- volvo 290/454 mercruiser
- 280 vs 290
- stren drives
- Volvo-Penta 270/280 Interchangable??
- mercruiser info
- Why not flexplate?
- Merc Stern Drive Problem
- Staggered? engine mounting...
- mercruiser outdrive trs2?
- OMC overheating, no apparent cause
- transom soundness
- Volvo Penta parts interchangeability
- Merc vs Volvo Outdrives
- where did the water come from?
- Don't know what the part is called, OMC??
- I/O Mercruiser sterndrive hour meter wiring
- Diesel on a volvo penta 200 stern drive
- max rpm on 5.7L
- Engine/Outdrive swap??
- Can't find the u-joint bellows...for my IMP with mercruiser II sterndrive
- Duoprop Compatibility - advice needed
- Mercruiser Alpha One grinding noise
- No Power Trim
- Bravo&torgue
- Diesel sterndrive & gear ratios
- Updating an Outdrive Question
- EFI and ventilation
- Water in engine - where did it come from???
- Mercruiser sterndrive won't go in gear ++
- 1987 Sea Ray...the problems are starting!
- Prop change for improving hull performance
- OMC 400 Outdrive stuck in fwd.
- noise in lower end
- Cooling System Question
- volvo 290 ?
- Is replacing and transom seal a do-it-yourself thing?
- 1987 sea ray won't engage forward drive
- Cobra shift lever question
- OMC outdrive plastic plug...
- 1990 Alpha One Stern Drive
- OMC Tilt
- Ignition and prop Questions
- Boat won't plane out when fully loaded
- rebuilt gm 350 stroker starting problem
- mercruiser alpha one 1.84 to 1.98
- sluggish take off
- Outdrive is mounted 1" off-center?
- Hard to find parts OMC Sterndrive
- Fix this block
- Proper Engine Alignment
- OMC King Cobras stolen Swap with?
- what next ??
- Starting Problem Mercruiser 5.7
- Removal Of Bell Housing ....Tools requires???
- hp and speed
- Carburator Issues
- Engine stalls in neutral
- Compression test mercruiser 350 magnum
- 5.7 mercuriser, Probs after sitting for a year
- volvo penta 290dp duoprop
- What prop next?
- 5 liter apha 1 engine stalls
- How to thoaout MecChuriser
- OMC 4.3 misses, sluggish - just bought it.
- bravo 3 drive
- Help with ratio and prop selection, please.
- cobra lower unit
- Gear ratio question
- cant get engine to stop running on???
- converting from I/O to outboard- cost vs efficiency
- Transom Bracket on 1986 IMP 200
- bad propeller torque
- Correct stern drive for Volvo engine
- need help getting submerged engine running
- Can't remove OMC cobra drive's HELP!!!
- May need sterndrive for a 400HP CAt 3406
- Mercruiser Alpha Gen II Gear Ratio Help
- Sterndrive installation
- Volvo Penta SP drive no reverse
View Full Version : Sterndrives
Pages : 1
[2]
Legal •
Boat Design Forums •
Gallery •
Directory •
Boat Design & Boatbuilding Bookstore •
Powerboat Ads •
Sailboat Ads
powered by vBulletin which is copyright ©2000-2012 Jelsoft Enterprises Ltd.
Web Site Design and Content Copyright ©1999-2012 Boat Design Net
powered by vBulletin which is copyright ©2000-2012 Jelsoft Enterprises Ltd.
Web Site Design and Content Copyright ©1999-2012 Boat Design Net