first time using fiberglass, seeking advice

[hoytedow]

Originally Posted by Conundrum_UK

it varied between nearly 20 degrees when I had both the heaters running to about 5 during the night, They were only kept at full power for about an hour though then turned down. The sample had, I think, most of the day at 15 degrees or more (though it may have dipped below that on a couple of occasions).

It looks like temperature was the problem though, I left that sample on a couple of hot water bottles by the radiator yesterday and now it's much stiffer and stronger. I guess it hadn't fully cured yesterday morning.

Anyway, sorry to dig up this thread again unnecessarily, guess I'll have to find some way to increase the temperature for the next batch.

Have you any news?