Boat Design Forums  |  Boat Design Directory  |  Boat Design Gallery  |  Boat Design Book Store  |  Thanks to Our Site Sponsors

Go Back   Boat Design Forums > Community > Open Discussion: All Things Boats & Boating
Register FAQ Members List Calendar Search Today's Posts Mark Forums Read

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 02-25-2009, 09:36 AM
Frosty's Avatar
Frosty Frosty is online now
Senior Member
 
Join Date: May 2002
Rep: 1693 Posts: 5,817
Location: Thailand
Desperate advice needed

It has been some time now that Ive had suspicions that my wife was seeing another man. You know the usual, ,--phone rings and no one there. I have waited up for her coming home but was not able to see anything.

Last night I hid in the garage behind the golf clubs. I waited for her return. She turned into the drive and I could see clearly that she was drunk. She got out of the car and fumbelled with her bra strap trying to re fasten it. She opened her hand bag and took out her knickers and put them on nearly tripping over as she got them cought on her high heels.

It was then that I noticed in the lights of a passing car that my wooden driver was cracked just below the head. Is this something I can fix myself or should I take it to the shop?
Reply With Quote
  #2  
Old 02-25-2009, 10:58 AM
BillyDoc BillyDoc is offline
Senior Member
 
Join Date: May 2005
Rep: 266 Posts: 421
Location: Pensacola, Florida
Frosty,

If you have a vacuum pump and a bell jar you can mix up some epoxy, enough to submerge the club head, and put the mixed epoxy and driver in the bell jar so that the head is submerged in the epoxy. You may have to weight the club head to keep it submerged. Then pull a good vacuum and when the bubbling stops or is minimal release the vacuum. The atmospheric pressure will force the epoxy into the crack. after a couple of minutes of atmospheric pressure with the club head submerged, pull the club head out and wipe off the excess epoxy. If the crack is not too wide surface tension should hold the epoxy in. If it is too wide for that, pull a plastic bag tightly over the crack to hold the epoxy in. You have to do all of this before the epoxy sets, of course. When the epoxy does set, peel off the plastic and you should be back in business.

If you don't have the vacuum equipment, I'd take it to the shop. There is no way you can fix this problem with common tools, and your clubs are too important to risk a poor fix!

BillyDoc
Reply With Quote
  #3  
Old 02-25-2009, 11:13 AM
daiquiri's Avatar
daiquiri daiquiri is offline
Engineering and Design
 
Join Date: May 2004
Rep: 2559 Posts: 2,726
Location: Italy (Garda Lake) and Croatia (Istria)
You've made my day, Frosty.

If it wasn't for your wife, that club head could have cost you a game, so I think you should really go and express her all your gratitude.
Reply With Quote
  #4  
Old 02-25-2009, 03:59 PM
masalai masalai is offline
masalai
 
Join Date: Oct 2007
Rep: 1689 Posts: 7,498
Location: SE Queensland, Australia
My question is, was the crack as a result of mistaking her head for a golf ball on the tee? or her for a criminal wielding a knife whilst threatening you and stealing your property? - in the former case repair thyself and quickly, in the latter (ensure the knife is in the thief's hand) and have the golf shop do the repairs as insurance should cover replacement costs?

A separate letter will be sent explaining legal ramifications and an invoice requiring immediate payment....

Is this a new format for the drivel thread? - where is the boat interest? appropriate message reads "You must spread some Reputation around before giving it to Frosty again."
__________________
Try to be helpful...
Remember that there are at least two sides for every story...
Reply With Quote
  #5  
Old 02-25-2009, 08:39 PM
mydauphin mydauphin is offline
Senior Member
 
Join Date: Apr 2007
Rep: 501 Posts: 1,760
Location: Florida
Epoxy your wife... Bagging optional... She will never cheat again...
Reply With Quote
  #6  
Old 02-26-2009, 04:36 PM
Fanie's Avatar
Fanie Fanie is offline
Fanie
 
Join Date: Oct 2007
Rep: 2057 Posts: 4,291
Location: Safrica
Well Frosty, I would have been pissed too. Have you seen what those drivers cost lately.

Golf clubs are very important to have aboard. You can keep pirates at least a couple of hundred yards away if the friggin wooden driver isn't cracked just below the head.

Well, at least you can enjoy the time the balls last.

I wonder if pirates will trade the wife for something else usable ?
__________________
Regards
Fanie

Water ! Just gimme water !
Reply With Quote
  #7  
Old 02-26-2009, 04:46 PM
Landlubber's Avatar
Landlubber Landlubber is offline
Senior Member
 
Join Date: Jun 2007
Rep: 1506 Posts: 2,456
Location: Brisbane
Hey are Golf Clubs like Yacht Clubs?
__________________
"I do not know, what I do not know!"
Reply With Quote
  #8  
Old 02-26-2009, 06:19 PM
masalai masalai is offline
masalai
 
Join Date: Oct 2007
Rep: 1689 Posts: 7,498
Location: SE Queensland, Australia
in my youth I was ambidextrous, and I can assure you there are lots of similarities - a hole (whole) in one may cost you a round at the bar (one is embarrassing one is boasting rights), both have water hazards for the inebriated, both have alcohol and food for sale (sail?), membership costs are about the same, membership is similar, one you walk around to hit a ball - the other you ball around to hit a walk, both are places where poets and liars lubricate their lips/tonsils. Monica is not a member, to win at the game for each, one is looking for low numbers and maximising ones handicap...
__________________
Try to be helpful...
Remember that there are at least two sides for every story...
Reply With Quote
  #9  
Old 02-26-2009, 07:30 PM
Landlubber's Avatar
Landlubber Landlubber is offline
Senior Member
 
Join Date: Jun 2007
Rep: 1506 Posts: 2,456
Location: Brisbane
well I fit the handicap part, not so sure about the rest......
__________________
"I do not know, what I do not know!"
Reply With Quote
  #10  
Old 02-26-2009, 08:09 PM
masalai masalai is offline
masalai
 
Join Date: Oct 2007
Rep: 1689 Posts: 7,498
Location: SE Queensland, Australia
Just use your imagination and post your thoughts which for a mono person may mean "need more lead bricks in the bilge" - or "a bigger and heavier keel", ( to fall off and let the mono roll over ) - and die like a good trick dog? - - - I saw someone with the t-shirt logo "if it is not a cat it is a dog".... but thought that a bit naf and rubbing it in a little
__________________
Try to be helpful...
Remember that there are at least two sides for every story...
Reply With Quote
  #11  
Old 02-26-2009, 09:11 PM
Landlubber's Avatar
Landlubber Landlubber is offline
Senior Member
 
Join Date: Jun 2007
Rep: 1506 Posts: 2,456
Location: Brisbane
Hey that is just plain rude....who was this "Cat"?

I still like my boats to "have a bit of bite".....
__________________
"I do not know, what I do not know!"
Reply With Quote
  #12  
Old 02-26-2009, 09:11 PM
Landlubber's Avatar
Landlubber Landlubber is offline
Senior Member
 
Join Date: Jun 2007
Rep: 1506 Posts: 2,456
Location: Brisbane
phew....cough.....cough.....another fur ball.
__________________
"I do not know, what I do not know!"
Reply With Quote
  #13  
Old 02-26-2009, 11:20 PM
masalai masalai is offline
masalai
 
Join Date: Oct 2007
Rep: 1689 Posts: 7,498
Location: SE Queensland, Australia
hehehehe
__________________
Try to be helpful...
Remember that there are at least two sides for every story...
Reply With Quote
Reply



Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
Desperate Need Of Help By Peers... Sean Herron Open Discussion: All Things Boats & Boating 15 02-21-2008 09:28 AM
SC advice needed workboat Software 4 07-31-2007 05:08 PM
Hi everyone.. Advice Needed LoneRider Open Discussion: All Things Boats & Boating 10 06-22-2006 11:55 PM
Advice Needed KSC Boat Design 1 02-20-2005 09:44 PM
Advice needed! biggathanjesus Materials 6 05-28-2004 10:44 AM


All times are GMT -5. The time now is 09:33 PM.


Powered by: vBulletin Copyright ©2000 - 2012, Jelsoft Enterprises Ltd.
Web Site Design and Content Copyright ©1999 - 2012 Boat Design Net