 |  |
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors |
| ||||
|
#1
03-21-2006, 10:54 AM
| |||
| |||
| Cold molded boat repair I have a 1967 Ray Hunt designed 25' Surf Hunter powerboat. It is cold molded usinf three 1/8" mahogany layers bonded with Resorsinol. The outter layer has received a beating over the years so I am considering bonding on another layer. This boat is big and heavy enough so that putting the hull up is not an option meaning that the sheathing would have to be done from underneath. Has anyone had experience doing this type of repair? If so, what constructive advice can you oass along? Thank you.  |
 |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Strip planking / Cold molded ? | fcfc | Wooden Boat Building and Restoration | 22 | 05-19-2005 08:55 PM |
| Plastic boat repair | Gator man | Fiberglass and Composite Boat Building | 2 | 09-16-2004 01:23 PM |
| Wood Cold Molded Epoxy/Composite Builders | winap | Wooden Boat Building and Restoration | 6 | 07-23-2004 07:02 AM |
| Cold Molded Construction & Long Term Value | fishboat | Powerboats | 2 | 06-03-2003 03:02 PM |
Linear Mode
