|
|
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors | Sitemap |
|
|
||
|
INDEX_____________________________________VOLUME I______________________________________Page vii
Page
.
JOB 4 - Laying Mesh and Rods on Deck................... 131
Task 1 Laying First Four Layers of Mesh on Deck............. 132
Task 2 Weld Longitudinal Reinforcing Rods Over Deckbeams........ 132
Task 3 Weld Athwartship Reinforcing Rods Above Deck Longitudinal Rods . . . 133
JOB 5................................. 134
Task 1 Apply Bulwarks Screed................... . 134
Task 2 Weld Bulwarks Longitudinal Rods................ 136
Task 3 Bend Bulwarks Sheer Rods................... 136
Task 4 Fair Bulwarks and Weld Sheer Rods in Place............ 137
Task 5 Fair Hull Steel Reinforcing................... 139
Task 6 Weld Deck Steel Reinforcing to Hull Framework.......... 140
JOB 6 — Hatch Coaming and Scuppers.................... 141
Task 1 Fabricate Hatch Coaming Screeds................ 141
Task 2 Weld Hatch Coaming Reinforcing in Place............. 141
Task 3 Make Scuppers....................... 142
Task 4 Weld Scuppers in Place.................... 144
JOB 7 - Mesh Deck, Coaming and Bulwarks.................. 145
Task 1 Laying Four Layers of Mesh Above Deck Reinforcing Rods...... 146
Task 2 Mesh Coaming and Bulwarks ................ ............................................................ 147
JOB 8 - Stringers and Sole Supports..................... 148
Task 1 Mark Sole Support Positions.................. 148
Task 2 Weld Sole Support Starter Rods................. 148
Task 3 Weld Sole Support Screeds................... 149
Task 4 Weld Diagonal "D" Stringer Screeds............... 149
Task 5 Mesh Sole Supports and Diagonal "D" Stringers........... 149
JOB 9 — Installation of Engine Beds and Stern Tubes............... 150
Task 1 Mark Engine Bed Positions................... 150
Task 2 Fabricate Engine Bed Screeds.................. 150
Task 3 Install Engine Bed Reinforcing................. 151
Task 4 Fabricate Stern Tubes..................... 154
Task 5 Prepare Stern Tube Alignment Sights............... 155
Task 6 Align and Weld Stern Tubes in Place............... 156
Task 7 Mesh Engine Beds and Stern Tubes................ 158
JOB 10 - Install Rudder Stuffing Box Supports................. 158
Task 1 Prepare Rudder Stuffing Box Housings.............. 158
Task 2 Mark Rudder Stuffing Box Positions............... 159
Task 3 Install Rudder Stuffing Box Housings and Fabricate Supports..... 160
Task 4 Mesh Rudder Stuffing Box Supports............... 161
|
||
|
|
||