|
|
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors | Sitemap |
|
|
||
|
INDEX VOLUME I Page v
Page
JOB 3 — Assemble Frames, Deck Beams and Suspension Rods........... 61
Task 1 Lay Hull Frame Pairs in Place on Lofting Floor........... 61
Task 2 Lay Deck Beam onto Frame and Mark.............. 61
Task 3 Cut and Weld Deck Beam in Place................ 61
Task 4 Make Deck Knee Bending Jig.................. 62
Task 5 Weld in Deck Knee...................... 63
Task 6 Weld Lower Suspension Rods to Hull Frame............ 65
Task 7 Weld Athwartship Braces.................... 65
Task 8 Weld Bulwark Supports.................... 66
Task 9 Weld Keel Sections...................... 67
Task 10 Weld Rod Reinforcing to Solid Bulkheads............. 68
Task 11 Weld Webs to Hull Frames................... 68
Task 12 Fasten Mesh to Bulkheads, Bulwark Supports and Webs........ 69
JOB 4 — Erecting Overhead Supports..................... 75
Task 1 Measure Off Base....................... 75
Task 2 Layout and Fasten Wooden Base Plates.............. 75
Task 3 Bolt Piping Base Plate to Wooden Base Plate............ 75
Task 4 Prepare Piping Supports and Braces................ 75
Task 5 Weld Overhead Support Frames................. 75
Task 6 Preparations for Erection of Support Frames............ 76
Task 7 Erect Overhead Support Structure................ 77
Task 8 Align and Weld Overhead Support Structure............ 77
Task 9 Weld Channel to Support Structure at Buttock No. 2 Lines...... 77
JOB 5 — Establish Base and Support Lines................... 79
Task 1 Make Center Line and Buttock No. 2 Lines............. 79
Task 2 Mark Water Lines...................... 79
Task 3 String the Water Line Around the Four Corners of the Structure ..................... 79
Task 4 String Vertical Center Line and Buttock No. 2 Lines......... 80
JOB 6- Make Stem Piece......................... 81
Task 1 Measure and Cut Stem Piece Rod................ 81
Task 2 Bend Rod to Shape of the Stem Piece............... 81
JOB 7 — Hanging Frames, Fairing Frames, Welding Stringers............ 82
Task 1 Cut Upper Suspension Rods to Size............... 82
Task 2 Weld Upper Suspension Rods to Hull Frames............ 82
Task 3 Mark Hull Frame Positions on Longitudinal Girders......... 82
Task 4 Weld First Hull Frame to Overhead Support Structure........ 83
Task 5 Weld Remaining Hull Frames to Overhead Support Structure...... 84
Task 6 Make Alignment Frames for Bow Hull Frames........... 85
Task 7 Plumb One Hull Frame and Brace 88
|
||
|
|
||